NO SAINTS™ - Strobe Kit ❕
NO SAINTS™ Strobe Kit — Plug. Sync. Blind 'Em.
NO SAINTS™ Strobe Kit is a compact, hard-wired wireless strobe controller built for car culture. Whether you're running undercarriage effects, grille flashes, or interior accent lights — this kit gives you full wireless control from the palm of your hand.
What's in the Kit
- NO SAINTS™ branded control module — compact black housing with dual wire leads for direct battery or accessory wire connection
- 4-button copper wireless key fob (A / B / C / D) — control up to 4 channels independently
- Extended wire leads — route through doors, under the dash, or through the firewall
- 16 different strobe modes !
Simple 3-Step Install
- Connect the wires — run the red (+) lead to a 12V power source (battery or switched accessory) and the black (–) lead to ground. No soldering required — use standard quick-connect terminals or ring terminals.
- Mount the module — the housing has built-in mounting tabs. Zip tie or bolt it anywhere out of sight — under the dash, in the trunk, or behind a panel.
- Pair the fob — press and hold the programming button on the module, then press any button on the fob. LED confirms pairing in seconds.
How It Works
Each button on the fob (A, B, C, D) controls an independent relay channel. Tap once to toggle on/off, or hold to activate strobe mode. Frequencies and patterns depend on your connected lights — the module handles the switching so your lights respond instantly.
Works with: LED strips, HID strobes, accent lights, relay-controlled accessories
Specs
- Voltage: 12V DC
- Wireless range: up to ~100ft / 30m line of sight
- Channels: 4 (A / B / C / D)
- Fob: 4-button copper RF key fob with carabiner clip
- Module: Branded NO SAINTS™ black housing
Install at your own risk. For off-road and show use. Not intended for road-going vehicles in jurisdictions where strobe lighting is prohibited.